Aeroponics Botanicare 4x4 16 sites

aeroguerilla

got the new room setup 20x20 ft with 8 4x4 botanicare 16 sites 500gph pumps intrested to test the aero out. got 8 1000 watt sunsystems switchable ballast 2 350cfm fans each powering 4 lights taking air in from the outside and pushing it back outside straight shot so noo lag in air stream... for co2 i have a 36 burner from green air along with cdmc7 controller and monitor... for nutes im useing the new advanced nutrients connoseur... strains- 64- soma ny diesel and 64 skunk/northern/neville homemade =) big yielder i use windmill for power... the only concern is watering temp in 40 gal rez? any thoughts??? theres a rough idea of my op id love to hear wat u all have to say about this!!!

aeroguerilla

questions for fellow aeromasters:

water temp of rez @ 40 gal?

ppm on nutes? week 1-2 (3 in clones) nutrient solution-advanced nutrients connoisseur a+b

i have another question concerning my air... i have two separate chambers of air because the hot air from the lights gets blown right threw allowing for the co2 to never escape... my question is should i use another blower to bring in separate air on a timer?? or do i not even need to do that... can the plants grow with just co2 in a confined area or do they need more air from outside??

iamcannaclubmember

aeroguerilla...welcome to stoner forums....


First aero grower?

Temp for a eaz that big should be between 50 to 60 degrees for good circ to the root system...at 50 to 60 % temp u get better nute delevery to ur roots so u'll be cool at that temps..




Now the air/co2 question....your gonna still need fresh air to ur plants buddy...

u can setup a timer to turn on a fresh air intake fan for a few mins a day to help with fresh co2/ I have my co2 generator setup on a timer to turn off/on when the fresh air intake fan comes on and off....so in other words have the fresh come on and the co2 turn off and vise versa...
hope this helps...if not pm me and i'll be ever so glad to help...

iamcannaclubmember

nutes and clones....
are they all clones ur working with?

What ppm u working with now?

clnoes start best at a ppm of 250 up too 450..( depending on strain )...

A safe start is 300 ppm for clones...(i've never gone wrong with the 300)...so good luck.....